Application Notes from AIC

• Conversion tables & Range guides
  • Conductivity Cell Range Guide - AN31
  • Pressure conversion chart (approximate values) - AN33
  • Wind Speed Conversion Table - AN34
     
• Conductivity
  • AIC conductivity cells installation guide - AN23
  • SDI conductivity cells installation guide - AN24
  • Conductivity Cell Range Guide - AN31
  • Conductivity cell & test solution information - AN4
  • Cleaning & maintenance of conductivity cells - AN3
  • Quick calibration values for conductivity cells - AN2
  • Wiring code for AIC conductivity cells - AN25
     
• pH and ORP/Redox
  • Inexpensive submersion assembly for pH & ORP electrodes - AN11
  • Quick calibration values for pH electrodes - AN2
  • Terminating pH cable when BNC connectors are not used - AN8
  • TH3-OR transmitter calibration procedure - AN32
  • TH3-PH transmitter calibration procedure - AN10
  • Using pH signal amplifier to increase transmission distance - AN5
     
• Weighing, load, pressure, level
  • Load cell system fault finding guide - AN1
  • PM4-WT connection to P+F barriers/repeaters, External supply - AN27
  • PM4-WT connection to P+F barriers/repeaters, PM4 supply, 4-wire - AN28
  • PM4-WT connection to P+F barriers/repeaters, PM4 supply, 6-wire - AN26
  • Pressure conversion chart (approximate values) - AN33
  • Simple test circuit for PM4-SG & PM4-WT inputs - AN12
  • Wiring & switching for two load cells to single input instrument - AN17
     
• Temperature
  • Connect AD590 sensor to PM4-IV panel meter - AN30
  • Quick calibration values for temperature sensors - AN2
  • TH3-RT transmitter calibration procedures - AN9
     
• General
  • Blank 50 point lineariser table - AN22
  • Connecting one 4-20mA transducer to 2 PM4 analog monitors - AN19
  • Factory calibration of PM4 analog retransmission - AN6
  • How the AIC digital filter works - AN18
  • Replacing lexan in new style PM4 bezel - AN29
  • Troubleshooting guide to common PM4 meter setup problems - AN14
  • Using PC422 converters to extend serial transmission distance - AN16
  • Using RMSI422 DIN rail converters to extend serial distance - AN15
  • Wind Speed Conversion Table - AN34
  • Link to manuals for discontinued products - AN35
  • Pinout for "flip" digit connector - AN36